| Description: |
Bale Opener Line for RDF and MSW Cross Wrap Oy BO 4000
used machine
Technical data of the bale opener line:
Manufacturer Cross Wrap Oy
Ltd, Siilinjärvi, Finland
Type BO 4000
Year of manufacture
2015
Quantity of opened bales 674 pieces
Operating time only 3
days, exclusively by running in the entire line during new
installation
Opening time approx. 45 seconds per bale
Bale
dimensions (W x H x L) 1100 x 1100 x 1400 - 1900 mm
Max. Bale
weight 2,000 kg
Conveying height of the system 1,400 mm
Max.
Conveying width of the system 1,200 mm
Material to be opened
RDF/MSW
Availability of the line 98%
Noise level of the bale
opener line 85 dB(A)
Total connected load 37 kW
Rated current
125 A
Operating display SIEMENS SIMATIC HMI Touch
Control
SIEMENS S7 ET200S
Installation dimensions 8,463 x 2,890 x 3,960 mm
(l x w x h)
Scope of delivery:
Feed conveyor 3,500 x
1,200 x 1,400 mm
Feed conveyor to opener 1,500 x 1,200 x 1,400
mm
Bale opener (gripper with knife)
Special
equipment:
Oil heating in hydraulic oil tank
Heating in
control cabinet
Oil cooler in Hydraulic unit
Explanation
of the short period of use:
The entire line of Cross Wrap bale
openers type BO 4000 was installed at a municipal waste incineration
plant in 2015. The background to the installation was that in the case
of a malfunction or maintenance of the incinerator, the municipal
waste could continue to be received, baled, wrapped and stored until
the malfunction was cleared. Then the bales should all be opened again
and the waste fed into the normal incineration process.
This
worst-case scenario never came to pass. The plant was set up, run in
and then never used in regular operation. Only during the
commissioning and running-in of the entire plant in 2015 were 674
bales opened on three days. The plant is in very good condition and
ready for operation immediately. Due to reconstruction measures in the
incineration plant, the installation area of the bale opener was
needed. As a result, the entire line is for sale.
Short
description of the wrapping process:
The pressed bales are placed
on the infeed conveyor belt from the side or from behind by means of a
forklift O1251246 truck. For opening, the bales must run horizontally
to the conveyor belt with the wire or twine binding, otherwise the
bales must be turned 90° beforehand. The opening conveyor brings one
bale at a time in front of the cutting unit. The grippers hold the
wires or twine strapping. The front and rear rotating knives slit the
bale lengthwise. Afterwards, the gripper returns to the starting
position. The opened bale is now conveyed via the conveyor belt to the
discharge chute and then falls onto the following conveyor
system.
Comments:
New price of the completely plant
296.000,- ?. The documentation (operating instructions, CE
declaration, electrical/hydraulic circuit diagram) is complete. The
unit has been dismantled into freight-manageable units, stored and is
available for inspection and loading at short notice. We do not accept
any liability for the technical details or any errors.
seller offer
No. resale Cross_Wrap_Bale_Opener_BO4000
|